AppSuite:GuardCluster

From Open-Xchange
Revision as of 13:07, 21 May 2021 by Choeger (talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

OX Guard Clustering

IMPORTANT

If nothing else, make sure the oxguardpass file is the same for all Guard servers. This is the local password file that is used to encrypt some database items. If this varies between machines, there will be failures with password recoveries and cached key creation

Pre-Installation

  • Please make sure that the database is accessible from all of the Guard servers (usernames allow for the Guard IPs)
  • Set up a filestore that can be accessed from all Guard servers. This may be a Networked File Store (NAS), or Amazon


Setup

Configuration

OX Backends

On each OX backend, make sure the packages open-xchange-rest and open-xchange-guard-backend are installed. Edit the /opt/open-xchange/etc/server.properties file to make sure the REST API username and password are configured. Please see the setup instructions for details.

First machine

First, setup the guard.properties file to the needed settings.

  • Make sure that the com.openexchange.guard.storage.file.uploadDirectory setting refers to the NAS
  • Make sure the right username/password for the REST API are set
  • Make sure all database settings are set for names that can be used from all guard servers (i.e. don't use localhost)
  • If installing on the same server as an OX backend, it is possible to use localhost as the restAPIHostname, but if not, make sure goes through the same load balancer or routing as the users
    • Guard uses JSESSIONID, like the user interface, for routing
    • Guard uses the users cookie data to authorize against the backend to retrieve emails, etc.
    • If routed to a different backend than the user, there will be excess sessions created


Run the /opt/open-xchange/sbin/guard --init on the first machine only

Once init is done, the oxguardpass file will be created. This file will need to be copied to all other Guard machines.

Other machines

Copy the oxguardpass file from the first installation into /opt/open-xchange/guard Make sure that the guard.properties file for that machine is configured with the same required settings as the first. You may be able to just copy the guard.properties file from the first depending on your setup.


Startup

Once above is done, guard can be started.